Associated Equipment; Prohibited Use - Tractel mobifor Manual De Instalación, De Utilización Y De Mantenimiento

In case of anomaly or damage noted on the anchor
point, its use should be immediately stopped until duly
refurbished and handed over by a qualified technician.
GB
The person in charge of the use of the mobifor™ anchor
point shall provide a rescue procedure for the operator
in the event of a fall and for any other emergencies,
so that they can be evacuated in conditions compatible
with the preservation of their health. It is recommended
that each operator is equipped with a mobile phone
listing the number to call in a case of emergency
IMPORTANT: At no time should the operator be
disconnected from the mobifor™ anchor point when in
an area where there is a risk of falling. In particular,
when the operator passes from one anchor point to
another, this passage must be done by means of a pair
of lanyards (or a double lanyard) constantly attached to
the operator's fall arrest harness, one of which is kept
available, and connected to the attachment point of the
second anchor point, before disconnecting the other
lanyard on the first attachment point of the previous
anchor point.
When the mobifor™ anchor point has undergone the
fall of an operator, the entire anchor point and the
personal protective equipment involved in the fall must
be checked before being returned to use by a person
qualified to do so.
9. Uninstallation
Before any uninstallation, the installer must check that:
• All conditions are met to guarantee their security
during the uninstallation in accordance with the
regulations in force.
• The mobifor™ anchor point is not in use or
might be used by an operator (multipoint anchor
installation).
• Identify a location for block storage under
conditions that guarantee the integrity of the
support and the stability of the blocks.
IMPORTANT: If the blocks are stored stacked, the
installer must ensure that the support structure and the
support surface are sufficiently robust. Tractel
recommends limiting the stacking of blocks to 3 high.
Uninstall procedure
1. Remove the 16 concrete blocks not locked vertically.
2. Remove the 4 outer blocks after unlocking them
from the folded end of the arm by sliding them off.
3. Remove the 4 inner blocks after having unlocked
them from the folded leg of the central structure by
sliding them off.
4. Remove the 4 arms by lifting them by their bent end
and sliding them out of the central structure.
→ The uninstall is complete.
12
IMPORTANT: After uninstallation, the installer must
ensure that the sealing surface does not show any
particular deterioration, for example after a fall.

10. Associated equipment

An EN 363 fall arrest system is made up of the following
components:
• An anchorage (EN 795).
• An extremity connector (EN 362).
• A fall arrest system (EN 355 – EN 360).
• A connector (EN 362).
• A fall arrest harness (EN 361).
Authorized devices:
• Blocfor ™ fall Arrest: B5 ESD - B6 ESD - B10 ESD -
B20 ESD in accordance with EN360
• Absorbing lanyard fall arrest : LDA - LDAD - LSA -
LSAD - LSEA in accordance with EN355
Any other association is forbidden.

11. Prohibited use

It is strictly forbidden:
1. to install or use this equipment without the proper
authorisation, training and recognition or, failing
that, without the supervision of an authorised,
trained and recognised competent person.
2. to use this equipment if any of the markings are not
legible.
3. to install or use this equipment without first having
carried out the preliminary checks,
4. to use this equipment which has not been covered
by a periodic inspection over the past 12 months
by a technician having authorised re-use in writing,
5. to use this equipment in contradiction with the
information specified in the section " Lifespan",
6. to use this equipment as a fall protection system for
®
more than 1 person,
7. to use this equipment by a person whose weight,
equipment included, is greater than 100 kg.
8. to use this equipment in a highly corrosive or
explosive atmosphere.
9. to use this equipment outside the temperature
range specified in this manual,
10. to use this equipment if you are not in good physical
condition,
11. to use this equipment if you are pregnant,
12. to use this equipment if the safety function
of any of the associated items is affected by the safety
function of another item or may interfere with it.