Use And Maintenance - Teka P21310R01 Instrucciones Para La Instalación Y Recomendaciones De Uso Y Mantenimiento

EN
The board must be fitted 20 mm bene-
ath the under part of the stovetop.
Electrical connection
Before you connect the stovetop to
the mains, check that the voltage
and frequency match those specified
on the stovetop nameplate, which is
underneath it, and on the Guarantee
Sheet, or if applicable on the technical
data sheet, which you must keep
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
top housing or the oven housing, if it
is installed in the same unit.
Warning:
The electrical connection must
be properly grounded, following
current legislation, otherwise the
induction hob may malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
fig. 1
22
high temperature that this type of
device attains.
Only the TEKA official techni-
cal service can handle or repair the
appliance, including replacement
of the power cable.
Before disconnecting the hob
form the mains, we recommend
switching off the cutoff switch and
waiting for approximately 25
seconds before disconnecting from
the mains. This time is required to
allow for the complete discharge of
the electronic circuitry and thus
preclude the possibility of electric
shock from the cable terminals.
Keep the Guarantee
Certificate or the technical
data sheet together with the
instructions manual throughout
the product's service life. These
contain important technical
information.
Use and
Maintenance
User instructions of the
Touch Control
HANDLING ELEMENTS (fig. 2)
1
General on/off sensor.
2
Power and time selection knob
3
Zone's selection sensor and
indicator.
4
Power and/or residual heat
indicator.
5
Timer indicator.
6
"Block" sensor and indicator.
7
"Stop&go" sensor and indicator.
8
"Timer" sensor and indicator.
9
"Synchro" sensor and indicator
(depends on the model).
10
"Keep Warm" sensor and indicator.
11
"iQuickBoiling" sensor and
indicator.
12
Off sensor
13
Knob's absence indicator
* Only visible while running.
The manoeuvres are done by means
of the touch keys and knob. You do
not need to exert force on the desired
touch key; you only need to touch
it with your fingertip to activate the
required function
Each action is verified by a beep.
Any knob's rotation (2) allows power
levels adjustment between 0 and 9
and time adjustment between 0 and
99. Turning rightwards the knob, the
value will be increased, whilst turning
it leftwards will be decreased.
In order to select a plate on
these models, directly touch the
zone selection sensor (3).
SWITCHING ON THE DEVICE
1 Insert the knob (2) in its working
housing (see figure 3).
2 Touch the On touch key
least one second. The touch control
will become active and visible, and
the external ring will be lighted.
If any cooking area is hot, in the
power indicator (4) will show an H.
Figure 3
(1) for at