Use And Maintenance - Teka IBR 6040 Instrucciones Para La Instalación Y Recomendaciones De Uso Y Mantenimiento

GB
Only the TEKA official techni-
cal service can handle or repair the
appliance, including replacement of
the power cable.
Before disconnecting the hob
from the mains, we recommend
switching off the cut-off switch and
waiting for approximately
seconds before pulling the plug.
This time is required to allow for the
complete discharge of the electro-
nic circuitry and thus preclude the
possibility of electric shock from
the contacts of the plug.
Keep the
Certificate or the technical data she-
et together with the instructions
manual throughout the product's
service life. These contain impor-
tant technical information.
Use and
Maintenance
User instructions
of the Touch Control
HANDLING ELEMENTS (fig. 2)
On/off touch key.
1
Hotplate signaller.
2
3 Power and/or residual heat displays*.
fig. 1
18
fig. 2
25
Hotplate selection touch keys.
4
Guarantee
5 Decimal point for the clock*.
Clock touch key.
6
Clock indicator.
7
Locking touch key for the rest of
8
touch keys.
Decimal point of the power and/or
9
residual heat indicators*.
10 Lock activated display*.
1 1 "Minus" power/time reduction touch
key.
"Plus" power/time increase touch
12
key.
* Only visible while running.
The manoeuvres are done by means of
the touch keys. You do not need to exert
force on the desired touch key, you only
need to touch it with your fingertip to
activate the required function.
Each action is verified by a beep.
If one or several touch keys remain
pressed for more than ten seconds,
the hob will automatically switch off for
safety reasons and the beep alarm will
go off as a warning of the possible
danger situation.
SWITCHING ON THE DEVICE
1 Touch the On touch key
least one second. The touch control
will become active, a beep will be
heard and the indicators (3) will light
up displaying a "-". If any cooking
area is hot, the related indicator will
H
flash an .
If you do not take any action in the next
10 seconds the touch control will
switch off automatically.
When the touch control is activated,
you can disconnect it at any time by
touching the touch button
if it has been locked (lock function acti-
vated). The touch button
always has priority to disconnect the
touch control.
ACTIVATING HOT PLATES
Once the touch control has been acti-
vated with touch key
ired hotplates can be switched on.
1 Select the desired hotplate by pre-
ssing the related touch key (4).
0
An will appear in the related power
indicator and the decimal point will
stay on indicating that the hotplate is
selected.
2 With the touch key
(12/11) select the desired power
level (from 1 to 9).
(1) for at
(1), even
(1)
(1), the des-
or