Operating Instructions; Useful Recommendations; Lcd Display - Imetec L0101 Manual De Instrucciones

Ocultar thumbs

página de 52

/ 52
Contenido
Tabla de contenido
Marcadores

Idiomas disponibles

Always make sure the appliance is completely dry before using and charging it.

• Switch the appliance on by pressing the

• Insert the adaptor (22) into an electrical socket.

• Connect the charging cable (22) to the connector (1) at the base of the hair trimmer [Fig. B1].

• The LCD display (4) will turn light blue [Fig. B2] and the numbers will and the battery symbol will flash

and the symbol indicating the mains will appear.

• For more information about the display indications, refer to LCD DISPLAY.

Do not keep the appliance always connected to the socket.

Always switch off and unplug the hair trimmer after use and after charging.

To preserve the battery life of the hair trimmer:

• Do not charge every day. It is recommend to discharge the battery completely every six months and then

charge it for 12 hours.

• Do not exceed the recommended charging time. Excessive charging will reduce the durability of the

rechargeable batteries.

• If you do not intend to use the product for a long period of time, recharge it for 12 hours before putting it away.

If the battery life ends, replace it with the same model supplied with the product by requesting it from an

authorised service centre.

The product is equipped with an Li-Ion lithium battery. Keep away from sources of heat; risk of explosion.

ATTENTION! Never use the appliance if the blades are damaged or the blade locking

device does not work properly.

Warning: never use the appliance on wet hair.

Make sure the hair is dry and clean, with no trace of hairspray, hair mousse or gel. Then brush the hair in the

direction of growth to remove all knots.

ATTENTION! Switch the appliance off before changing any accessories.

USING SPACER COMBS (14-15-16-17-18-19-20)

Follow these instructions to insert a spacer comb:

Spacer comb

Setting

number

None

• Choose the desired spacer comb, apply it on the product and select the length from the adjustment button (8).

• Ensure that the spacer comb is inserted properly into the grooves on both sides.

• With the spacer comb attached, the appliance has 21 different hair length settings and an additional 3

settings without any accessories.

• Adjust the spacer comb to the desired length by pressing the adjustment button (8) and sliding it to the

desired length setting.

• Switch the appliance on by pressing the

USING THE SPACER COMBS (14-15-16-17-18-19-20)

The appliance can also be used without the spacer comb to trim hair very close to the skin (0.5 mm) or shape

around the nape of the neck and the area around the ears.

USEFUL RECOMMENDATIONS

• Start with the highest setting of the spacer comb and gradually decrease it until you have the desired hair length.

• For optimal results, use the device with the blades facing the opposite direction of hair growth.

• Move the appliance in different directions (upwards, downwards and sideways) because not all hair

grows in the same direction.

• If a lot of hair has accumulated in the spacer comb, remove the comb from the appliance and blow and/

or shake out the accumulated hair.

• Take note of the hair length settings used to create a certain style as a reminder for future sessions.

LCD DISPLAy

• The product is equipped with an LCD display (3) that indicates:

• battery charge: 20/40/60/80/100%.

• battery charge illustrated by the battery symbol .

• mains symbol

• When the battery is fully charged, the colour of the LCD will be light blue. When it is low, the colour will

turn red and the battery symbol

product needs to be charged.

• If the battery is completely flat, the LCD will light up in red, the numbers and the battery symbol will flash

and the symbol indicating the mains will appear