Flying - Carson MINIMOA HB-282 Instrucciones De Uso

FLYING

GB GB
Pre flight check
Like any real airplane, the model aircraft should
undergo a complete pre flight check. This begins
with visually checking that all parts are in the
correct place and firmly attached to the model.
Next, switch on the radio equipment and test for
Testing the reach of the radio system
MINIMOA
Before flying your
is vital to check the range of the radio signal.
- Switch on the transmitter first, then connect
the receiver.
- Slowly increase the distance between the
transmitter and the model, which should be
held by a second person as precautionary
measure. Ensure that they keep the
propeller away from any part of their body
Requirements of the flight terrain
There are different regulations from country to
country governing model aircraft. Pay attention to
the corresponding safety precautions in choosing
your flight area.
The ideal location is a model airplane club with its
own facilities or large field with short grass.
There should be no animals, people, traffic or
parked vehicles present.
Never fly near large obstacles, electricity pylons or
overhead cables.
Obtain information about the weather and wind
velocity via the media (TV, newspaper, radio etc)
before you commence flying, in order to avoid the
risk of starting in unsuitable conditions. Never fly in
strong wind, rain or thunder.
If you are a beginner you should avoid flying in
16 MINIMOA CARSON R/C MODEL GLIDER 50 050 5016
the correct operation of the ailerons etc. The
voltage indicator of the transmitter must indicate
sufficient power for the flight to commence. In the
event of a hard landing any damaged items must
be completely repaired before flying is resumed.
for the first time it
Never fly if your radio system does not work
perfectly, even if it is a temporary fault.
conditions where there is
anything other than a very
light wind.
- Operate the steering sticks in short intervals
and monitor the reaction of the rudders.
- Your R/C is performing well if the rudders
show the correct response at a distance of
about 300m between transmitter and the
model.