Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Use of lithium-ion rechargeable battery
1
Fully charge the battery (at least 1.5 hours)
before using for the first time. Connect the
battery charger to socket (16). When the
rechargeable battery is being charged, the
LED on the charger lights up red. When the
LED changes to green, charging is complete.
The LEDs (11, 13, 15) flashing indicates that
the battery charge level is low. In that case,
recharge the battery. The battery can be
charged while using the device.
– The battery may only be charged with the battery charger provided
and used only in this laser device. Any other use may cause injury
or fire.
!
– Make sure there are no conductive objects in the vicinity of the
battery contacts. Short-circuiting of these contacts can cause burn
injuries or fire.
– Do not open the rechargeable battery. This could cause short-circuits.
Horizontal and vertical levelling
2
Turn the transport fastener (2) clockwise and release the pendulum lock.
The lasers are now automatically aligned by the pendulum system and the
horizontal laser lights constantly. The lasers can be switched on and off with
the H and V buttons. It is now ready for levelling in the horizontal or vertical
plane.
Switch on
1x
device
V
V
1x
CombiCross-Laser 5 DLD
H
1x
13
GB
Publicidad
Tabla de contenido
