Safety Warnings - Astralpool LUMIPLUS MINI 3.13 Manual De Instalación Y Mantenimiento

In the case of concrete pools with a liner, the 59983/60229 niche should be embedded into the concrete wall (see the
niche's manual).
1. Put the seals, liner, and flanges in place (Fig. 5).
2. Fit the adaptor using the 11/2" nut with the help of the spanner provided (Fig. 6).
3. Put the Mini 3.13 projector into place and adjust using the spanner provided (Fig. 7).
4. Finally, attach the faceplate supplied with the niche (Fig. 7).
For spas or prefabricated pools (2" nut):
1. The projector should be placed approximately 400 mm below the spa's water line making sure it is not placed somewhe-
re that could easily be covered by a person's body. It should preferably be placed on the wall where the spa's steps are
found (Fig. 1).
2. Using a diamond tile drill bit, drill a hole 60 mm in diameter into the wall Fig. 9).
3. Place the rubber seal and the projector in the spa. Check that the seal and the part of the projector that will be in
contact with it are free of all dirt.
4. Place the 2" GAS nut on the outer part of the spa's shell and screw it to the body of the projector (Fig. 9).
For polyester pools (1½" thread):
Neither the snap-on adapter nor the O-ring seals will be used in this assembly.
1. Fit the adaptor using the 11/2" nut with the help of the spanner provided (Fig. 10)
2. Put the Mini 3.13 projector into place and adjust using the spanner provided. Attach the faceplate (Fig. 6 -7).
If the electrical connection has to be handled:
1. Remove the faceplate using a screwdriver as a lever (Fig. 11).
2. Use the spanner provided to reach the spotlight (follow the steps in Fig. 7 in reverse order).

5. SAFETY WARNINGS:

• Before any handling ensure that there is NO voltage supplied to the projector.
• People in charge of assembly should be suitably qualified for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS.
• Do not handle with wet feet.
• Do not clean using abrasive products that could damage the projector.
• The LEDs in this projector are classified as risk group 2.
• Under no circumstances should the luminaire be stared into for one minute or more at distances equal to or less than
20 cm. Doing so could damage eyesight.
6. ASSEMBLY AND FUNCTIONING WARNINGS:
• Maximum water temperature 40ºC.
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The projector is designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric compo-
nents which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• This projector is seawater resistant.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the
following levels:
Chlorine
Bromine
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
TYPE OF TREATMENT CONCENTRATION IN WATER
2 g/l
5 g/l
3