HP OFFICEJET PRO 8500A Guía De Instalación Inicial página 13

Step 2: Test fax setup
Test your fax setup to check the status of the
printer and make sure it is set up properly
for faxing.
The fax test does the following:
• Tests the fax hardware
• Verifies the correct type of phone cord is
connected to the printer
• Checks that the phone cord is plugged
into the correct port
• Checks for a dial tone
• Checks for an active phone line
• Tests the status of your phone line
connection
Step 3: Configure fax settings
Change the printer's fax settings to meet
your needs after you have connected the
printer to a phone line.
Note: To use the same fax resolution
and lighter/darker settings for all faxes
sent from the printer, configure the
settings as you wish, and then touch
Set as New Defaults.
1. From the printer's control panel, touch
right arrow and then touch Setup.
2. Touch Tools, and then touch Run Fax
Test. The printer displays the status of
the test on the display and prints a
report. After the test is finished, the
printer prints a report with the results of
the test. If the test fails, review the report
for information on how to fix the
problem and rerun the test. For
additional troubleshooting information,
see "Problems setting up the printer" on
page 24.
3. Once the fax test has run successfully,
go to "Step 3: Configure fax settings"
on page 1 1.
Where can I change fax
settings?
You can configure fax settings using
the following tools:
Printer's control panel
Touch Fax on the printer's control
panel, touch Settings, and then select
the setting you want to configure.
HP software
If you have installed the HP software
on your computer, you can configure
fax settings using the software that was
installed on your computer.
For more information about using these
tools or settings, see the user guide.
Set up and use fax 1 1