Nolan M44 Seguridad E Instrucciones página 24

- Always check that the VPS is properly positioned according to the
different weather/environmental conditions and/or to the above mentioned
recommendations for use.
- We recommend using the VPS only and solely together with the approved
standard visor, which has a transmittance value greater than 80%.
- Since the VPS does not assure you the same protection as the one provided
by the visor, it has to be used only when the helmet visor is pulled down.
- Always make sure that the VPS is clean and that it is operating properly in order
to avoid scratches and/or anomalous wear on it every time it is activated.
- ALWAYS check the correct VPS operation and in case of malfunctioning do
not use the helmet and contact immediately a Nolan authorized dealer.
- Please refer to the proper section in the helmet user's manual for the VPS and
visor maintenance and cleaning operations.
- The VPS anti-fog / anti-scratch treatment highly reduces fogging. Protracted
periods of adverse weather and/or environmental conditions might cause
fogging and/or formation of condensation on the VPS, which entails a reduction
of visibility and/or sharpness of vision: in this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the anti-fog / antiscratch-
treated VPS quickly reduces sharpness of vision, thus causing scarce visibility:
in this case, deactivate the VPS.
- The special VPS anti-fog treatment is usually sensitive to high temperatures or
heat sources. In this case, contaminations caused by contact with other
materials might occur. These contaminations will cause marks and stains to
develop. In these cases (e.g. when the helmet is kept in the top case on hot
days), it is recommended to make sure the visor is not touching other materials.
1. VPS DISASSEMBLY
The VPS has been designed to ensure an easy, quick and tool-free disassembly.
To remove the VPS system from the helmet, open the chin guard and lower the VPS by
pushing the side slider forwards (Fig. 11).
Hold the SX side part of the VPS and pull the VPS to front of the helmet (Fig. 13) in order
to release it from the side frame inside of the shell.
Repeat the same operation on the DX side of the helmet .
2. VPS ASSEMBLY
To assemble the VPS system, open the helmet chin guard and make sure the side slider
is in forward position (Fig. 11).
Insert the VPS SX end into the left side frame inside the shell until you hear a click
providing the fastening of the VPS (Fig. 13).
Repeat the same operation on the DX side.
Make sure the VPS operates correctly by activating and deactivating it according to the
instructions above.
- If the visor and/or VPS opening/closing mechanisms are damaged or
malfunctioning, do not use the helmet and contact immediately a Nolan
authorized dealer.
19