Proline PGH4FGL-FR Manual De Instrucciones página 27

To adjust the gas rate
With a thin bladed screwdriver (not supplied), completely tighten down the by pass
adjustment screw. When finishing adjusting the gas rate, stick the replacement rating
label on the underside of the hob.
OPERATION
Switching On a Burner
1. Press the control knob of the required burner and turn it anticlockwise to the
maximum power setting.
While the control knob is still pressed down, sparks will be produced on the
burner. The flame will ignite.
In case of ignition failure, you can use any type of lighter or flame (cigarette
lighter, matches, etc.) and bring it close to the burner. CARE MUST BE TAKEN
when using this method.
2. Release the control knob.
3. Turn the control knob to the required setting.
Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off the burner and open a nearby
window or door to ventilate the room. Wait at least 1 minute before trying to switch
the burner back on.
If you cannot light the burner even after several attempts, check the cap and crown are
in the correct position.
To determine which knob controls which
burner, check the position symbol next to the
control knob.
12