Publicidad
EN
INSTALLATION INSTRUCTION
A) Bring the shutter in position of complete closure.
B) Effect on the tube of the shutter 3 non passing perforations (figure 1); If the motor is not equipped with electrobrake, make only
perforation B.
C) Remove the crown of the motor , unscrewing the screws M8 (FIG. 2).
D) Extract from the chassis, with delicacy, the band with rolls in plastics, avoiding heavy folds that would cause the spillage of the
rullinis. Do not effect this operation in case of motors RANDY 76 and RANDY 101, since they do not endowed with band to rolls (FIG. 2).
E) Disassemble the chassis of the motor, unscrewing the four screws M8.
F) In case the tube of the shutter is inferior to the diameter of the hole chassis motor, you must mount the sleeves reduction positioning
them with reference to the hole A diameter 10 mms, (fig. 1).
G) Assemble on the tube of the shutter the chassis part with electric motor, with the second part of the chassis trought the four screws
M8 (FIG. 2).
H) Verify that the electric motor is placed on the right side rolling shutter and screw the TE M10 (hexagonal screw without nut, placed on
the foreground part of the second part of the chassis) screwing it inside the hole M10, effectuated before on the tube of rolling shutter
(FIG. 3).
I) Mount on the chassis neck, the band with rolls, being careful not to make strong folding to prevent spillage of rolls. Do not effect this
operation in case of motors RANDY 76 and RANDY 101, since they do not endowed with band with rolls (FIG. 2).
L) Mount on the chassis the two demicrown, rolling them on the band with rolls and fix them with the two screws M8. In case of motors
RANDY 76 and RANDY 101 the crown will rotate directly on the chassis neck turned (FIG. 2).
M) Shut the motor on the tube of the shutter through the screw TE M10 with nut (hexagonal screw with nut, placed on the background
part of the second part of the chassis).
N) Make 12 mms hole in the last element of the shutter, in correspondence of the filleted hole M10, existing on the crown motor.
O) Place the last element of the shutter on the motor and secure it through the screws M10 with washer 10 X 30.
P) Introduce the electric cable 4X1 into the hole B (fig 1), avoiding any contact with the parts in movement. Perform the electric
connections according the electric plan (fig.4). In presence of motor with electrobrake, introduce the sheat of the brake inside the second
hole B.
Q) As completed the electric plant, proceed to the regulation of the limit switches as following(fig. 5):
open the plastic cover of the limit limit unit;
•
rotate the right aluminum washer , set on the limit switch unit, toward right around 2-3 cms; give tension to the motor through
•
an electric command and verify if the shutter, climbing, stop in desired point. Adjustments of the position can be effected acting
always on the same aluminum washer and operand through electric command, absolutely avoiding manual liftings; found the
desired position, to shut the washer M5 (regulation up effected);
close again the plastic cover of the limit switch unit.
•
rotate left, clockwise, the aluminum washer positioned on the roller limit switch unit, up to detach with a click the left switch;
•
tighten the washer M5 (regulation down effected);
Publicidad
