Publicidad
EN
WARNINGS FOR THE INSTALLER - GENERAL SAFETY OBLIGATIONS
1) ATTENTION! To ensure the safety of people, it is important that you read all the following instructions. Incorrect installation or
incorrect use of the product could cause serious harm to people.
2) Carefully read the instructions before beginning to install the product.
3) Do not leave packing materials (plastic, polystyrene, etc.) within reach of children as such materials are potential sources of danger.
4) Store these instructions for future reference.
5) This product was designed and built strictly for the use indicated in this documentation. Any other use, not expressly indicated here,
could compromise the good condition/operation of the product and/or be a source of danger.
6) Manufacturer declines all liability caused by improper use or use other than that for which the automated system was intended.
7) Do not install the equipment in an explosive atmosphere: the presence of inflammable gas or fumes is a serious danger to safety.
8) The mechanical parts must conform to the provisions of Standards EN 12604 and EN 12605.
9) Manufacturer is not responsible for failure to observe Good Technique in the construction of the closing elements to be motorised, or
for any deformation that may occur during use.
10) The installation must conform to Standards EN 12453 and EN 12445. For non-EU countries, to obtain an adequate level of safety, the
Standards mentioned above must be observed, in addition to national legal regulations.
11) Before attempting any job on the system, cut out electrical power.
12) The mains power supply of the automated system must be fitted with an all-pole switch with contact opening distance of 3mm or
greater. Use of a 6A thermal breaker with all-pole circuit break is recommended.
13) Make sure that a differential switch with threshold of 0.03 A is fitted upstream of the system.
14) Make sure that the earthing system is perfectly constructed, and connect metal parts of the means of the closure to it.
15) The safety devices (EN 12978 standard) protect any danger areas against mechanical movement Risks, such as crushing, dragging,
and shearing.
16) Use of at least one indicator-light is recommended for every system, as well as a warning sign adequately secured to the frame
structure, in addition to the safety devices.
17) Manufacturer declines all liability as concerns safety and efficient operation of the automated system, if system components not
produced by manufacturer are used.
18) For maintenance, strictly use original parts
19) Do not in any way modify the components of the automated system.
20) The installer shall supply all information concerning manual operation of the system in case of an emergency, and shall hand over to
the user the warnings handbook supplied with the product.
21) Do not allow children or adults to stay near the product while it is operating.
22) Keep radiocontrols or other pulse generators away from children, to prevent the automated system from being activated
involuntarily.
23) The user must not attempt any kind of repair or direct action whatever and contact qualified personnel only.
24) Transit is permitted only when the automated system is idle.
25) Maintenance: check at least every 6 months the efficiency of the system, particularly the efficiency of the safety devices (including,
where foreseen, the operator thrust force) and of the release devices.
26) Anything not expressly specified in these instructions is not permitted.
Publicidad
