W)Lan Connection - Resol KM2 Manual De Instrucciones

Carry out the connection of the device  to the controller / other mod-
ules in the order described below:
Î Connect the data cable (RESOL VBus
extend the cable using a 2-wire cable (bell wire).


Î Connect VBus ® accessory  via the data cable, if necessary.
If a further VBus cable is to be connected, proceed as follows:
®
Î In order to open the housing, unscrew the screw and remove the upper part
of the housing.
Î Connect the 2-wire cable (bell wire) to the 2 VBus
any polarity.
Î Close the housing.


Î Connect the device to the mains by means of the mains adapter .
Î For a direct connection to a router, connect the device to a router  using the
network cable (included with the device, ). Or use the WLAN.
26
, ) to a RESOL controller . If necessary,
®

® terminals (A) and (B) with
(A) (B) (C) (D)
Connection terminals of the Communication module
www


3.3

(W)LAN connection

The KM2 Communication module can be connected to a router by using a net-
work cable (CAT5e, RJ45 or similar) or via WLAN (see chap. 4.2 on page 27).
Î Connect the network cable included to the LAN connector of the router and
to the LAN connector of the KM2.
For the next step of commissioning, see chap. 5.2 on page 30.
The LAN connector is located on the front side of the device and supports trans-
fer rates of up to 100 MBit per second.

