Gas Conversion - Viking VGCC530 Guia De Instalacion

IMPORTANT–Please Read and Follow!
• Before beginning, please read these instructions completely and carefully.
• Installation and service must be performed by a qualified installer, service agency or the gas supplier.
Parts List - LPKVGC
(1) PA070005
(1) PB040199
(2) PB040202
(1) 044710-000
(1) PB040275
(1) 044711-000
(1) F21264 Installation Instructions
(1) PF030377 Conversion Label
CAUTION
Before proceeding with conversion, turn off gas supply to
the appliance prior to disconnecting the electrical power.

Gas Conversion

1. Disconnect electrical power to cooktop.
2. Remove the surface grates.
3. Remove the burner caps (Item 1) by lifting up.
4. Use a small socket or nut driver to go down through the
burner base (Item 2) to remove the orifice (Item 3). (Tip:
Ball up a small piece of masking tape or some putty and
put in the end of your socket to stick to the orifice for
removal and replacement). If you do not have a tool
small enough to fit through the burner base (Item 2),
remove the burner base to get access to the jet holder
(Item 4).
5. Remove the regulator in the rear right from underneath
the unit. Replace the gas regulator with the supplied
regulator and reassemble. Sealant on all pipe joints must
be resistive to natural or LP/Propane gas.
6. Manifold pressure should be checked with a manometer
and requires 10.0" W.C.P for LP gas. Incoming line
pressure upstream from the regulator must be 1" W.C.P.
higher than the manifold pressure in order to check the
regulator. The regulator used on this cooktop can
withstand a maximum input pressure of 1/2 PSI (14.0"
WCP). If the line pressure is in excess of that amount, a
step-down regulator will be required.
7. Replace the burners and grates.
LP Regulator
Drill Dia. mm
#56 .046 1.17
#63 .037 0.94
----- .030 0.76
#70 .028 0.71
---- .034 0.86
This conversion kit shall be installed by a qualified
service agency in accordance with the
manufacturer's instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions
is not followed exactly, a fire, explosion, or
production of carbon monoxide may result causing
property damage, personal injury or loss of life.
The qualified service agency is responsible for the
proper installation of this kit. The installation is
not proper and complete until the operation of the
converted appliance is checked as specified in the
manufacturer's instructions supplied with the kit.
Before placing the cooktop into operation, always
check for gas leaks with a soapy water solution.
DO NOT use an open flame to check for leaks!
2
WARNING
Item 1
Item 2
Item 3
Item 4
CAUTION