Astralpool 71205 Manual De Instalación Y Mantenimiento página 3

4. ASSEMBLY:
LumiPlus FlexiSlim (See page 26) LumiPlus FlexiNiche / FlexiRapid (See page 28)
A description is given below of how to connect the LumiPlus Flexi to the cable to ensure the connection area is water-
tight. It is important to follow these steps:
1. Ensure that there is no voltage before handling any cable.
2. Put the O-ring seal in place.
3. Connect the cable to the spotlight and tighten the two screws.
4. Thread the cable through the cable gland seal nut.
5. Fit the cable gland to the body of the projector, as shown. Then screw in the three screws.
6. Ensure that the cable sleeve remains in place in the connection area and then tighten the cable gland using a wrench
(6Nw).
7. Ensure that that cable is firmly tightened so that it does not work loose from the cable gland.
8. Once connected, the projector can be fitted to the pool (see faceplate manual).
5. MAINTENANCE:
The LumiPlus Flexi does not require any maintenance. If you become aware that it is not working properly, please
contact our customer service department.
DO NOT ATTEMPT TO HANDLE THE INSIDE OF THE SPOTLIGHT AS THE PRODUCT WARRANTY WILL NO
LONGER BE VALID.
6. CONTROL MOTION:
Operating frequency: 868 MHz
Range in the open field: 5 m
Batteries: 2 AAA-1.5 V batteries.
Control Motion has 6 buttons: COLOR, REFRESH, SEQUENCE, SPEED (-/+), ON/OFF
REFRESH
The main functions on the remote control are:
CENTRAL DISPLAY
• COLOR: selects one of 12 standard colours available.
COLOR
• REFRESH: recovers the colour/sequences
• SEQUENCE: selects one of the 8 sequences available.
SEQUENCE
• SPEED: selects one of the 8 speeds available.
SPEED -/+
• ON/OFF: switches the LumiPlus Flexi On and Off.
ON/OFF
ATTENTION
DO NOT PLACE HAND OVER TOP OF THE BUTTONS ON CONTROL MOTION
7. OPERATION:
Control Motion makes it possible to control the LumiPlus Flexi using a keyboard or movement.
To ensure optimal light response, place the Control Motion close to the LumiPlus Flexi. If you have more than one light
source, place the device in the middle of the two to ensure optimal reception.
7.1 Remote control
- Switching LumiPlus Flexi On
By pressing the ON/OFF button for a few seconds, the LumiPlus Flexi will turn On.
- Selecting colours
The COLOR button enables you to select one of the 12 available colours. Each time the button is pressed, the colour
changes; when the last colour is reached, pressing again goes back to the first colour. The colour selected is displayed
in the Central Display.
3