Installer Setting - Test Run Mode - Friedrich MD12Y3JM Manual De Instrucciones

Installation

Installer Setting - Test Run Mode

After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
FAN
SPEED
TEMP
• What is the test run mode??
- This means the operation of the product under the cooling, strong wind, and Comp on state
without performing room temperature control in order to confirm the installed state during the
product installation.
24 Multi zone
OPER
MODE
1
When pressing the
button simultaneously for more than 3
seconds, the system will be entered into
the installer setting mode.
- After entering into the installer setting
mode, select the test run mode code
value by pressing the
* Test run mode code value : 01
2
When pressing the
operation mode will be performed, and it is
displayed as shown in the left figure.
3
When pressing the
button simultaneously for more than 3
seconds after the setting has been
completed, the setting mode will be
released.
- If there isn't any button input for more
than 25 seconds, the installer setting
mode will also be released.
4
When approx. 18 minutes are elapsed after
starting of the test oper-mode, the system
will be stopped automatically and converted
to the standby state.
- If any button is inputted during the test run
mode, the test run mode will be forced to
be relreased.
OPER
button and
MODE
OPER button.
MODE
OPER
button, the test
MODE
OPER
button and
MODE