Installer Setting - Celsius / Fahrenheit Switching - Friedrich MD12Y3JM Manual De Instrucciones

Installer Setting - Celsius / Fahrenheit Switching

This function is used for switching the display between Celsius and Fahrenheit.
(Optimized only for U.S.A)
FAN
SPEED
TEMP
• Whenever press temp up(▲), down(▼) button in Fahrenheit mode, the temperature will
increase/drop 2 degrees.
1
2
OPER
MODE
3
4
When pressing the
simultaneously for more than 3 seconds, the
system will be entered into the installer setting
mode.
- After entering into the installer setting mode,
select the ceiling height setting code value by
pressing the oper-mode button.
* Celsius/Fahrenheit setting code value : 07
Select the desired setting value with the
temperature up(▲), down(▼) button.
Code value
Value
When pressing button, currently
established celsius/Fahrenheit setting value
will be set up.
When pressing the
simultaneously for more than 3 seconds after the
setting has been completed, the setting mode will
be released.
- If there isn't any button input for more than 25
seconds, the installer setting mode will also be
released.
Installation
OPER
button and button
MODE
*Setting value
00:Celsius
01:Fahrenheit
OPER
button and button
MODE
Installation Manual 27