Placement Of Harness, Transmitter & Repeater - Luda Elektronik horseAlarm Guia Del Usuario

8. Placement of harness, Transmitter & Repeater
The included cable will allow you to place the Repeater within 7 meters from the R300 antenna
and within 2 meters* from a 220V socket. Maximum distance between horse and Repeater is 50m.
1. Check the state of the harness and sensors, clean the sensors and condition the leather if
needed.
2. Open the Transmitter by unscrewing the four screws. Be careful not to stretch the cables!
3. Put the batteries in the Transmitter, close, screw back the screws, then put it back in the
Transmitter pocket. Put the harness on the horse according to the illustration. To make it
comfortable for the horse, close the surcingle at the top. Also make sure that the rubber stop
is still on. It prevents the horse from opening the surcingle.
4. Mount the Repeater with the power and antenna connections facing down, within 7 meters
from where you will place the antenna, and 2 meters from a 220V socket.
5. Screw the small black antenna onto the left antenna connection of the Repeater.
6. Connect the 12V adapter marked with Repeater to the Repeater and then to the wall socket.
Make sure the Repeater is receiving a signal from the Transmitter, it should flash in green
every 20th second.
InFORMATIOn
*To lengthen the power cable, use a regular 220V extending cable. If you due to
security reasons do not wish to use high voltage cables close to your horses, you
can purchase a low voltage extending cable from your retailer.
DC
12V
- 16 -