Troubleshooting - Luda Elektronik horseAlarm Guia Del Usuario

17. Troubleshooting

Please follow the steps below to locate your problem.
You can contact our support team at: http.//ludaelektronik.com/support/en/
1. Is the Receiver working?
– If you can see a picture in the display the monitor is considered working. Please go to section
2.
– If you cannot see anything in the display but the ON LED is green, try pressing any button.
The display should lit up.
– If the ON LED is not glowing, plug in the power adapter. Wait an hour in case the battery level
is v ery low. If nothing happens, please contact the LUDA customer support.
2. Is the Link LED on the Receiver red?
– If it is, go to section 3.
– If it is green, please contact the LUDA customer support.
3. Is the Repeater working?
Disconnect the power from the Repeater and then connect it again. You should see a green
flash when the power is plugged in. Within 1 minute you should see a second flash.
– If you didn't see any flash, please check that there is power in your wall socket. If you have
power, contact the LUDA customer support.
– If you did see a flash at the start and then a second flash, please go to section 5.
– If you saw a first flash and then nothing or a constant green light, please go to section 4.
4. Is the Transmitter working?
Check if there is a green LED flashing every 20th second on the Transmitter box.
– If you didn't see any flash, change batteries in the Transmitter. If changing batteries doesn't
help, please contact the LUDA customer support.
– If you did see a flash every 20th second, please go to section 5.
5. Check the distance between the Transmitter and Repeater
Try moving the Transmitter and Repeater closer to each other and see if you get a signal. If
you get a signal you will see a green flash on the Repeater. Also check that the antennas are
connected to the right connections. (See chapter 8.)
6. Check the distance between the Repeater and Receiver
Try moving the Receiver closer to the outdoor R300 antenna and see if you get a signal. Also
c heck that the antennas are connected to the right connections on the Repeater. (See chapter
8.) Also make sure the antenna cable isn't damaged in any way.
- 22 -