Mounting The Antenna - Luda Elektronik horseAlarm Guia Del Usuario

9. Mounting the Antenna

To achieve the best signal reception, mount the antenna facing the house you will be receiving the
signal in, with no objects between.
1. Unplug the power to the Repeater, connect the antenna cable.
2. Drag the antenna cable to the point on the outer wall where you have chosen to mount the
antenna.
3. Mount the R300 antenna temporarily with 1 or 2 screws. Put the shrinking tube on the
antenna cable and connect it to the antenna. Plug in the power to the Repeater again.
4. Check the signal quality using the receiver at the intended receiving point. The scale to the
upper right on the screen shows the signal strength. Adjust the antenna if needed, or try
vertical position.
5. Mount the antenna with all four screws and heat the shrink tube over the antenna
connection when you are satisfied with the signal.
InFORMATIOn
Be careful not to break the cable when going around corners etc. Especially in
cold weather as the cable will be more sensitive.
Make sure there are no metal objects within 1 m of the antenna, as they may
cause interference.
90˚
Do not heat the shrinking
tube until you have checked
the signal strength!
- 17 -
90˚
EN
DE
ES FR
FI
SV
IT
FR
PL
SV