Receiver Mode - Advanced; Receiver Mode - Settings - Luda Elektronik horseAlarm Guia Del Usuario

13. Receiver Mode - Advanced

In advanced mode the horseAlarm will keep track and draw the history of the values. This means
that you can see what has happened during the last 6 hours, even if you have not been awake the
whole time. Both sweating and position is recorded. The screen updates every three minutes.
You can also see the stable temperature, making it easier to determine if the mare is sweating
because of heat or foaling.
How to read the position diagram:
If the horse is lying on its right side, a thick line will appear below the thin line.
If the horse is lying on its left side, a thick line will appear above the thin line.
How to read the sweat diagram:
The diagram will display how much the horse is sweating, 0 is the least and 15 is the most.
The chosen limit is shown as a small dot at the right of the screen and also as a number. Adjust
the sweat-limit with the A button. After 15 it will automatically go to 1.
Stable temperature
Position setting Alarm mode
Repeater
Horse ID
22
1
signal strength
5
Current
sweat level
Alarm sweat level
Current position
Sweat diagram Position diagram

14. Receiver Mode - Settings

Press the D button for a few seconds until the settings screen appear.
Setting the backgound light
Press the A button to change the background light setting between ON and AUT.
The default setting is Auto (AUT), where the backround will light up for five seconds after a button
is pressed. Keeping the light on will shorten the battery life of the receiver.
Thermometer settings
You can change between Celcius and Fahrenheit by holding the B button down.
Here you also have the possibility to calibrate the temperature as it is sometimes offset during pro-
duction. Press the B button to do this. Pressing one time increases the number with one degree.
Sound settings
Press the C button to change between OFF (0) or ON (1,2 or 3).
- 20 -