Troy-Bilt 020287 Manual Del Operario página 8

Section 3: Assembly
Attach Handle
I. Place handle assembly onto handle supports connected
to main unit. Hake sure holes in handle align with holes
on handle supports (Figure 2).
Handle
1 I Supports 1 I
NOTE: Itmay be necessaryto move the handlesupports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob on inside of handles (Figure 3).
Tighten by hand.
3. Insert multi-colored spray tips in spaces provided in
handle.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
CAUTION
• Refer to engine operator's manual for oil and fuel fill
information.
• Damage to equipment resulung from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break-in. Refer to
engine operator's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT:To avoid pump damage,you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
I. Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 4). Pull down
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of tight connection.
\ Connect high
pressure hose
here.
\
NOTE: Remove and discard all pump shipping caps before
attaching hoses.
O