Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
2_.
Similarly,
attach
other
end of high pressure
hose to
high
pressure
outlet
on pump
(Figure
5). Pull down
on
collar
of quick
connect,
slide onto
pump
and let go of
collar. Pull on hose to be sure of tight
connection.
•
-
-o
--
•
_ -
-
•
-
® _
D
Connect high
pressure hose here
3.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 6).
Clean screen if it contains debris, replace if damaged.
DO NOT RUN PRESSUREWASHER
IF SCREEN IS
DAHAGED
OR HISSING.
DO NOT use if
damaged or missin
clean if dirty.
4.
Run water through garden hose for 30 seconds to
clean out any debris.Turn
off water.
IMPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than IO0°F).
5.
Connect garden hose (not to exceed 50 feet in length)
to water
inlet.Tighten
by hand (Figure 6).
CAUTION
•
Damage to equipment
resulting from failure to follow this
instruction
will void warranty.
6,
Turn
ON
water,
point
gun in a safe direction
and
squeeze
trigger
to purge
pump
system
of air and
impurities.
WARNING
Always wear safety goggles when using this equipment
or in
vicinity
of where equipment
is in use.
Before starting the pressure washe_, be sure you are wearing
adequate safety goggles,
Checklist
Before
Starting
Engine
Review
the unit's assembly
to confirm
you have performed
all of the following:
I.
Hake
sure handle
is in place and secure.
2.
Check
that oil has been added
to proper
level in
engine
crankcase.
3.
Add
proper
fuel to fuel tank.
4.
Check
for
properly
attached
hose connections.
5.
Check
to make sure there
are no kinks, cuts, or
damage
to high pressure
hose.
6.
Provide
a proper
water
supply
(not to exceed
100°F)
at an adequate
flow.
7.
Be sure to read "Safety
Rules"
and "HowTo
Use
Pressure
Washer"
before
using pressure
washen
O
Publicidad
Tabla de contenido
