ELICA KIT0153054 Guía De Instalación, Uso Y Mantenimiento página 8

3 Remove the motor mounting plate by setting free the
spring clip. NOTE: The spring clip should be outside the
slot in the mounting plate.
4 Run out the power supply wires and connector through
the hole in the right end of the motor mounting plate.
5 Slide out the left mounting plate from under the motor
mounting bracket.
A. Motor mounting plate
B. Motor mounting bracket
B
6 Install the grease filters.
8
A
B
A. Mounting plate
B. Spring Clip
A
B
A. Mounting plate
B. Spring Clip
A
Prepare for Mounting the External Blower System
The External Blower System must be fastened to a secure
structure of the wall or new or existing frame construction.
The 7 holes on either the inlet (bottom) side or the outlet
(top) side of the blower must be used to mount the external
blower system to the structure.
NOTE: The mounting hole locations must span the studs.
Additional stud framing may be required. Plywood may be
used to span open areas between ceiling joists or roof rafters
to aid installation. This structure must be strong enough to
support the weight of the external blower system (83 lb [37.5
kg] min).
Prepare the External Blower System
I WARNING
Excessive Weight Hazard
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
1 Disconnect power.
2 Using two or more people, move the external blower
motor system to the mounting location.
3 Remove the 20 screws from the front cover of the external
blower motor housing and set them aside.
4 Remove the front cover of the external blower motor
housing and set it aside.
C
A. Front cover
B. Blower mounting
screws
A
B
C. Motor electrical
plug