Product Safety Information; Product Specifications; Installation And Lubrication; Parts And Maintenance - Ingersoll Rand 7802SA Especificaciones Del Producto

Product Safety Information

Intended Use:
It is designed to cut steel, aluminum, tin and other materials up to 20 gauge (1 mm).
For additional information refer to Air Shear Product Safety Information Manual Form 04580494.
Manuals can be downloaded from www.irtools.com.

Product Specifications

Handle
Model (s)
type
7802SA Pistol

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16573818 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts
be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll-Rand Office or Distributor.
Form 04580502-Edition 3
Max.
Free
Material
Speed
Thickness
Gauge/
Strokes/
Inch/
min.
mm
4200 20/.04/1.0
Sound Level dB (A)
(ISO15744)
Pressure (L )
p
"K "=3dB(A)
pA
83
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
Vibration Level
Power (L )
w
"K "=3dB(A)
wA
94
(ISO8662)
m/s²
3.4
3