Grounding Instructions; Extension Cords - Clarke Carpet Master 30 Libro De Instrucciones

Ocultar thumbs Ver también para Carpet Master 30:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
EN

GROUNDING INSTRUCTIONS

This machine must be grounded. If it should malfunction or
break down, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This
machine is equipped with a cord having an equipment-
grounding conductor and grounding plug. The plug must be
inserted into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and
ordinances.
WARNING: Improper connection of the
equipment-grounding conductor
can result in a risk of electric
shock.
electrician or service person if you
are in doubt as to whether the outlet
is properly grounded.
modify the plug provided with the
machine. If it will not fit the outlet,
have a proper outlet installed by a
qualified electrician.
This machine is for use on a nominal 120-volt circuit, and has
a grounded plug that looks like the plug illustrated in figure A.
Make sure you have the correct voltage and frequency
before connecting the power cord to an outlet. A temporary
adapter that looks like the adapter illustrated in figures B and
C may be used to connect this plug to a 2-pole receptacle as
shown in figure B if a properly outlet is not available. The
temporary adapter should be used only until a properly
grounded outlet (figure A) can be installed by a qualified
electrician.
The green colored rigid car, lug, or the like
extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box cover. When-
ever the adapter is used, it must be held in place by a metal
screw.
NOTE: In Canada, the use of a temporary adapter is not
permitted the Canadian Electrical Code.
WARNING: To prevent possible electric shock,
protect the machine from rain.
Keep the machine in a dry building.
WARNING: For maximum protection against
electrical shock, use a circuit that
is protected by a ground fault
circuit interrupter. Consult your
electrical contractor.
WARNING: Have worn, cut or damaged cords
replaced by an authorized service
person.

EXTENSION CORDS

Use only three-wire 14/3 AWG (AWG means American Wire
Gauge) or larger gauge approved extension cords that have
three-prong grounding type plugs and three-pole receptacles
that accept the appliance's plug.
damaged cords or plugs. When servicing, refer to authorized
person only. Use only identical replacement parts.
WARNING: If you use an extension cord, use an
extension cord with minimum wire
size 14 AWG.
extension cord longer than 50 feet.
Do not join two extension cords.
WARNING: Do not move the machine over an
electrical cord. Always lift the
cord over the machine.
Page
-4-
Check with a qualified
Do not
Replace or repair any
Do not use an
Figure A
Grounding
Pin
Cover of Grounded
Outlet Box
Figure B
Metal
Screw
Cover of
Grounded
Outlet Box
NOTE: Do not use adapters shown in figure B & C in Canada
Clarke
®
Operator's Manual (EN) - Carpet Master 30
Figure C
Grounding
Means

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido