C Ontrol; T Ools; P Reventive Maintenance; T Roubleshooting - SUHNER QUILLmaster BEM 3 Documentación Técnica

3.2 c
ontrol
3.2.1 c
ontrol of the machine
The motor can be turned on and off only (no frequency
converter installed).
3.2.2 m
onitoring
A directly controlled motor is equipped with thermal pro-
tection which has to be integrated in the PLC circuit by the
user. Please refer to section 2.2.1.
3.3 t
ools
3.3.1 i
nstallation of collet chuck
Insert the collet chuck into the clamping nut until the pull-
out knob snaps into the groove of the chuck. Screw the
clamping nut together with the collet chuck onto the drive
spindle. Insert the tool into the chuck and tighten down
the clamping nut to a maximum torque of 16 Nm.
Use only special wrenck included in product
package.
ER 11 / DIN 6499.
4. S
ERvIcE
4.1 P
reVentiVe maintenance
4.1.1 s
afety measure Prior to maintenance
Switch off the machine and separate from power supply.
4.1.2 m
aintenance instructions
Check belt tension after the first 50 operating hours.
4.1.3 l
uBrication chart
No lubrication required.
4.1.4 c
leaning
Clean fully extended quill periodically.
28
4.2 t
4.2.1 m
No reaction to the start signal: Check for correct function-
ing of inductive sensors.
4.2.2 r
Rapid travel functions only sluggishly, for not at all: Check
air compression value (5-7bars). Check air line for kinks.
Rapid travel functioning, but not followed by drilling travel:
Check adjustment of braking cylinder.
4.3 r
If despite strict observance of the manufacturing and test-
ing method the machine should happen to fail, it must be
repaired by an authorized SUHNER agency.
In all orders to the manufacturer please indicate the ma-
chine serial number (1).
4.4 w
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages.
/m
aINTENaNcE
Complaints can only be honored if the machine is re-
turned in the undisassembled condition.
4.5 s
Temperature range: 20°C to +50°C.
Max. relative air humidity: 90% at +30°C, 65% at +50°C.
4.6 D
This machine consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the machine unusable.
Do not throw the machine into the garbage collection.
rouBleshooting
achine
aPiD traVel
ePair
arranty
torage
/ e
isPosal nVironmental comPatiBility
According to national regulations this machine
must be recycled in an environmentally-friendly
manner.