Connection To The Measurement Unit - WEG SRW 01-UC Guía De Instalación, Configuración Y Operación

4. CONNECTION TO THE MEASUREMENT UNIT

The Current Measuring Unit (UMC) or Current/Voltage Measuring
Unit (UMCT) is connected to the Control Unit (UC) by means of a proper
ribbon cable, using the connector located in the upper part of the Control
Unit (UC). In order to install the cable, follow the procedures below:
The other end of the cable must be connected to the Current
Measuring Unit (UMC) or Current/Voltage Measuring Unit (UMCT) as
described in procedures 1(a) and 1(b).
NOTE!
Do not remove the connection cable by pulling the cable
itself, in order not to damage it.
8
1 (a) - Connection of the cable to the
UMC or UMCT
1 (b) - Connection of the cable to the
UMC or UMCT