BE CAREFUL! The transceiver meets IP67* requirements
for dust-tight and waterproof protection. However, once the
transceiver has been dropped, dust-tight and waterproof
protection cannot be guaranteed because of possible
damage to the transceiver's case or the waterproof seal.
* Only when the jack cover or the optional HM-168LWP,
HS-94LWP, or HS-95LWP is attached.
BE SURE to turn OFF the transceiver power before
connecting the supplied or optional equipment.
Even when the transceiver power is OFF, a slight current
still flows in the circuits. Remove the battery pack from the
transceiver when not using it for a long periods of time.
Otherwise, the installed battery pack will become exhausted,
and will need to be recharged or replaced.
Icom is not responsible for the destruction, damage to, or
performance of any Icom or non-Icom equipment, if the
malfunction is because of:
• Force majeure, including, but not limited to, fires,
earthquakes, storms, floods, lightning, other natural
disasters, disturbances, riots, war, or radioactive
contamination.
• The use of Icom transceivers with any equipment that is
not manufactured or approved by Icom.
TABLE OF CONTENTS
IMPORTANT .........................................................................1
DISPOSAL ............................................................................1
RECOMMENDATION ...........................................................2
PRECAUTIONS ....................................................................3
■ Front panel ...................................................................5
■ Caution .........................................................................7
4 OPTIONS ....................................................................... 11
4