En - SOME NOTIONS BEFORE USING THE QUADRAT
HOW TO GET A HYDROMASSAGE
To get the best benefits, have a hydromassage 3 times a week
maximum.
Before getting into the Quadrat, have a quick shower to remove
any greasy substances (i.e. sweat, body creams, etc.) that may
contaminate the water.
Take off any pendants and gather your hair to prevent it from get-
ting entangled in any mobile parts.
Check with a hand if the water of the Quadrat is pleasant and
immerse yourself slowly and carefully since the floor and Quadrat
itself may be slippery.
Bathing in the Quadrat should not last longer than 10 minutes.
Prolonged immersion in hot water can cause HYPERTHER-
MIA, that is excessive body temperature. The consequenc-
es of this state can be torpor, increase of the body tem-
perature, fainting, damages to the foetus in pregnant women and
unconsciousness with the consequent risk of drowning.
RECOMMENDED TEMPERATURES
The temperature of the water depends on personal preference
and the effect you wish to obtain:
Revitalizing effect: the temperature of the water must be set
at 33°C (maximum 10 minutes in the Quadrat). If you wish to use
the chromotherapy function, the best colours are yellow and red.
Relaxing and draining effect: the temperature of the water
must be set at 35-37°C (limit time in the Quadrat to maximum 10
minutes). If you wish to use the chromotherapy function, blue and
green are the recommended colours.
WHICH PRODUCTS TO USE
Use products suitable for Quadrats, that can be easily found in
specialized shops.
DO NOT use foaming detergents, soaps, greasy lotions and in general
products not compatible with the Quadrat materials.
Alternatively, you can use a moderate quantity of bath salts and
natural essences (i.e. lavender or neroli oils, etc.), making sure that
the product formulation is suitable to Quadrats.
If, after using the products, the water should be cloudy or foamy,
change it and clean the walls of the Quadrat; then try and use a
different product or use less of it.
QUADRAT CONTROLS
It is possible to control the Quadrat via the remote control supplied,
a control inside the bath or an internal keypad (accessible only from
the inspection compartment): in this last case, set the main values
before getting into the water.
As to the use specifications, see the following pages.
38
Quadrat