Bostitch PN100 Manual De Operación Y De Mantenimiento página 5

Clavadora industrial de impacto a alta velocidad
Ocultar thumbs Ver también para PN100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Do not use oxygen, combustible gases, or bottled gases as a power
source for this tool as tool may explode, possibly causing injury.
FITTINGS:
Install a male plug on the tool which is free flowing and which will release air pressure from the
tool when disconnected from the supply source.
HOSES:
Air hoses should have a minimum of 150 p.s.i. (10.6 kg/cm
percent of the maximum pressure that could be produced in the air system. The supply hose
should contain a fitting that will provide "quick disconnecting" from the male plug on the tool.
SUPPLY SOURCE:
Use only clean regulated compressed air as a power source for this tool. NEVER USE
OXYGEN, COMBUSTIBLE GASES, OR BOTTLED GASES, AS A POWER SOURCE FOR
THIS TOOL AS TOOL MAY EXPLODE.
REGULATOR:
A pressure regulator with an operating pressure of 0 - 125 p.s.i. (0 - 8.79 KG/CM
to control the operatiing pressure for safe operation of this tool. Do not connect this tool to air
pressure which can potentially exceed 200 p.s.i. (14 KG/CM
sibly causing injury.
OPERATING PRESSURE:
Do not exceed recommended maximum operating pressure as tool wear will be greatly
increased. The air supply must be capable of maintaining the operating pressure at the tool.
Pressure drops in the air supply can reduce the tool's driving power. Refer to "TOOL
SPECIFICATIONS" for setting the correct operating pressure for the tool.
FILTER:
Dirt and water in the air supply are major causes of wear in pneumatic tools. A filter will help
to get the best performance and minimum wear from the tool. The filter must have adequate
flow capacity for the specific installation. The filter has to be kept clean to be effective in provid-
ing clean compressed air to the tool. Consult the manufacturer's instructions on proper main-
tenance of your filter. A dirty and clogged filter will cause a pressure drop which will reduce
the tool's performance.
AIR SUPPLY AND CONNECTIONS
2
) working pressure rating or 150
2
)as tool may fracture or burst, pos-
-5-
2
) is required

Publicidad

Tabla de contenido
loading

Tabla de contenido