Eaton EGS100L24R Manual Del Usuario página 16

Instructional Booklet
Page 16 Effective: July 2008
7.4 Component Replacement
Certain components within the ATS are field replaceable. Table 4 lists the part numbers to use when ordering replacement components.
To order replacement components, contact an authorized Eaton sales representative.
Table 4. Field Replaceable Components.
COMPONENT
Contactor
RTC-50 Controller
Harness EGS
Service Entrance Breaker
Ground Bar
Lugs
Neutral Bar
SurgTel
SurgCable
TVSS
HIGH VOLTAGES ARE PRESENT IN AND AROUND TRANSFER
SWITCH EQUIPMENT. BEFORE ATTEMPTING TO REPLACE ANY
COMPONENT, DISCONNECT THE LINE POWER FROM THE EQUIP-
MENT BEING SERVICED BY OPENING AND LOCKING OUT, IF POSSI-
BLE, THE NEXT HIGHEST DISCONNECT DEVICE. FAILURE TO
FOLLOW THIS PROCEDURE COULD CAUSE SEVERE PERSONAL
INJURY AND/OR DEATH.
ALWAYS TURN THE UTILITY (SOURCE 1) POWER OFF AND TURN
THE GENERATOR (SOURCE 2) CONTROL SELECTOR SWITCH TO
THE "OFF" POSITION BEFORE ATTEMPTING TO REPLACE ANY COM-
PONENTS.
APPLY UTILITY (SOURCE 1) POWER AND PLACE THE GENERATOR
CONTROL SELECTOR SWITCH IN THE "AUTO" POSITION AFTER THE
COMPONENT HAS BEEN REPLACED. TEST THE SYSTEM FOR
PROPER FUNCTIONALITY.
PART NUMBER
99-5638
RTC50
99-5638-3
99-5638-4
99-5638-15
99-5638-6
99-5638-17
DHW4PT
DCXCAB2
99-5638-10
WARNING
NOTICE
For more information visit: www.eaton.com
O & M Manual for the EGS AutomaticTransfer Switch
with RTC-50 Control and Integral Loadcenter - 100 Amp
7.4.1 Component Replacement Instructions
7.4.1.1 100 Ampere RTC-50 Controller
RTC-50
Controlle
r
Figure 13. Controller Board Installed in a EGS ATS.
ATS MODEL
100 A
100 A
100 A
100 A
100 A
100 A
100 A
100 A
100 A
100 A
IB70-8671