Safety Information - Stanley ST-12F-DDF-E Manual De Usuario E Instrucciones De Funcionamiento

CAUTION Automatically Operated Device - To Reduce The Risk Of Injury
WARNING
Disconnect From Power Source Before Servicing
To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-
WARNING
State Speed Control Device.
To Reduce The Risk Of Electric Shock And Injury To Persons, Do Not Use In a
WARNING
Window.
To Reduce The Risk Of Electric Shock, Do Not Expose To Water Or Rain or us in
WARNING
damp locations.
Do not operate any fan with a damaged cord or plug. Discard fan or return to an
WARNING
authorized service facility for examination and/or repair. Do not run cord under car-
peting. Do not cover cord with throw rugs , runner, or similar coverings. Do not route cord under fur-
niture or appliances. Arrange cord away from traffic areas and where it will not be tripped over.
Installation work and electrical wiring must be done by qualified person (s) in accor-
WARNING
dance with all applicable codes and regulations.
When servicing or replacing a component requires the removal or disconnection of
WARNING
a safety device, the safety device is to be reinstalled or remounted as previously
installed before operating this fan.
Use this fan only in the manner intended by the manufacturer. If you have any ques-
WARNING
tions, contact Customer Service at 800-641-6996.
- Before operating always check fan for loose or damaged parts. Inspect power cord for any dam-
age. Never use fan if any parts are
damaged or missing. Never use fan without safety guards attached.
- Operate only on 120 volt 60 Hz (cycle) current with a minimum of a 15 amp circuit.
- When used with an extension cord, use only cord of proper size (Amp rating), UL listed, and with
receptacle to accept three prong grounded plug furnished on the fan's power cord. Always keep
power cord and extension cords away from heat, oil, and sharp edges. Inspect cords periodically
and replace if damaged.
Installation and Assembly: ST-12F-DDF-E / ST-20F-DDF-E / ST-20FO-DDF-E /
Place the fan on level ground in a safe, desired position then connect to an approved power
-
source.
© 2016, Pinnacle Climate Technologies, Inc.
NEVER LEAVE A FAN UNATTENDED WHILE
OPERATING OR WHILE CONNECTED TO A

Safety Information

ST-24-DDF-E
3
POWER SOURCE