Tabla De Contenido - Metra 99-3018 Instrucciones De Instalación

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Can be used in non-amplified, or analog/digital amplified models *
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• Retains balance and fade
• Micro "B" USB updatable
* Please reference the "Service Parts Identification" sticker located under the
spare tire cover. If the RPO code UQA is listed, then the vehicle is equipped
with an analog "DELCO" amplifier. If the RPO code UQS is listed, then the
vehicle is equipped with a digital "BOSE" amplifier.
INTERFACE COMPONENTS
• Axxess Interface
• 3018 harness
• 16-pin harness with stripped leads
• Resistor pad harness
99-3018
Axxess Interface Installation
7
Table of Contents
Connections to be made ............................................................................. 8
For models without an amplifier .......................................................... 8-9
For models with an analog amplifier ............................................... 10-11
For models with a digital amplifier .................................................. 12-13
Installing the interface ............................................................................. 14
Initializing the interface ........................................................................... 14
Adjusting the interface ............................................................................. 14
Final assembly .......................................................................................... 15
TOOLS REQUIRED
• Wire cutting tool
• Crimping tool
• Tape
• Connectors (example: butt-connectors, bell caps, etc.)