Kit Preparation - Metra 99-3018 Instrucciones De Instalación

1. Remove (4) Phillips screws to
remove the ashtray/pocket from
the bottom of the radio/climate
control panel. (Figure A)
2. Remove (4) T-10 Torx screws and
(16) Phillips screws to remove the
radio/climate controls, and radio/
climate bezel from the panel.
(Figure B)
Note: The radio/climate bezel will
not be used in this installation.
3. Remove (4) Phillips screws to
remove the upper screen
trim panel.

Kit Preparation

(Figure A)
(Figure B)
Remove shaded area
(Figure C)
99-3018
4. Cut the radio/climate control panel
clock support area as shown in
the diagram. (Figure C)
Note: Vent removal is optional.
5. Using the factory hardware, secure
the radio trim panel and the factory
radio/climate controls to the
modified factory panel. Use the (2)
supplied plastic washers on the top
two mounting positions.
(Figures D and E)
Continue to Kit Assembly
5
(Figure D)
(Figure E)