Korg STAGEMAN 80 Manual De Usuario página 14

STAGEMAN 80 Owner's manual
Using the tuner function
The STAGEMAN 80 has a built-in auto tuner.
Here's how to use it to tune your guitar.
1. Press the [TUNER] button to turn on the tuner (the
button lights up).
2. To change the calibration, turn the VALUE dial.
You can set the calibration in a range of 435–445 Hz.
By default, the calibration is set to 440 Hz.
3. Play any open string on your guitar.
The note name of the string that you play will appear on
the display.
Tune the string roughly until the desired note name
appears on the display.
1st string/6th string: "E"; 2nd string: "b"; 3rd string: "G";
4th string: "d"; 5th string: "A"
4. Tune the string accurately while you watch the [(1) 8
BEAT1] – [(24) SAMBA] buttons.
The buttons act as a meter. Tune so that only the two
vertical columns in the center are lit up.
5. When you've finished tuning, press the [TUNER} button
to turn the tuner function off.
Tip: When the tuner is on, you can use the [M1]–[M8]
buttons of the select section to play an audible guide tone.
Choose one of three sounds as the guide tone: guitar, bass,
or piano. The sound is switched each time you press the
[TAP/END] button.
Display Button
Guit
M1–M6
(guitar)
bass (bass) M1–M4
M1–M8, [(17) 16 BEAT], [(18) 16
Pian
BEAT SHUFFLE], [(20)JAZZ]–
(piano)
[(22)BOSSA]
14
1,5
2
Guide tone
Strings 1–6 (1E, 2B,
3G, 4D, 5A, 6E)
Strings 1–4 (1G,
2D, 3A, 4E)
C, D, E, F, G, A,
B, C, C#, D#, F#,
G#, A#
Using a mic
Let's try connecting a mic to the MIC IN jack. Only dynamic
mics can be used with the STAGEMAN 80.
Condenser mics are not supported on the STAGEMAN 80.
1
1,2
1. Set the MIC knob and VOLUME knob to the minimum
position, and connect your mic to the MIC IN jack.
2. While vocalizing into the mic, use the MIC knob to
adjust the mic's input level.
To avoid signal clipping (signal that's too loud) this knob should
be adjusted so that the peak LED doesn't light up when signal is
being input at a high volume level.
3. Use the VOLUME knob to adjust the volume that is
output from the speakers.
4. Use the TREBLE knob and BASS knob to adjust the
tone.
5. As necessary, use the REVERB knob to adjust the effect
as desired.
Tip: If you're using a VOX VFS5 foot switch, you can use
it to turn reverb on/off.
6. If you enable the Acoustage function by pressing the
[ACOUSTAGE] button, the audio output from the
STAGEMAN 80 will be heard in an expansive stereo
field.
6
5
4 1,3