Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
ToP CuTTiNg
Use a wide sweeping motion (See Fig. I). A
slight downward tilt of the cutting blades in
the direction of motion gives the best cutting
results.
SidE CuTTiNg
When trimming the sides of the hedge, begin
at the bottom and cut upwards (See Fig. J),
tapering the hedge inward at the top. This
shape will expose more of the hedge, resulting
in a more uniformed growth.
8. CLEaNiNg
ReMOVe The BATTeRY PACK. Use a soft brush
to remove debris from all air intakes and
cutting blade.
Wipe the surface with a dry cloth.
warNiNg: Never use water for
cleaning your trimmer. Do not clean with
chemicals, including petrol, or solvents as this
may damage your trimmer.
12
12
LuBriCaTiNg ThE CuTTiNg BLadE
For easier operation and longer life, lubricate
the cutting blades before and after each use.
Before lubricating, make sure the battery is
removed from the trimmer. Apply oil between
the two blades periodically (See Fig. K).
aT ThE ENd oF ThE CuTTiNg SEaSoN
Clean your trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the trimmer for any worn or
damaged parts.
9. SToriNg your hEdgE TrimmEr
1) aSSEmBLy ThE waLL mouNT
BraCkET (See Fig. L)
Before you attach the wall-mount bracket
to the wall, make sure to check the charger
cable length to the wall socket. Attach the
wall-mount bracket to the wall with the screws
provided.
Tighten all screws securely. Carefully check the
bracket after mounting to make sure that no
movement can occur during use.
warNiNg: Always make sure your
wall-mount bracket is securely mounted
Cordless Li-ion hedge trimmer
to the wall. Failure to do so could result in an
accident, resulting in possible serious personal
injury.
2) SToriNg your hEdgE TrimmEr (See
Fig. m)
Insert the hedge trimmer into blade sheath,
and then store the hedge trimmer into the wall
mount bracket as illustrated.
Store in a dry place where your trimmer can
be protected from damage.
MAINTENANCE
remove battery from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
EN