Intended Use; Assembly And Operation - Worx WX385 Manual Del Usuario

Do not burn
Li-I on
Do not dispose of batteries, Return
exhausted batteries to your local
collection or recycling point.
Hammer drilling
Screwdriving
Drilling
8
Wood
Metal
Brick
High speed
Low speed
Waste electrical products must not
be disposed of with household
waste. Please recycle where
facilities exist. Check with your local
authorities or retailer for recycling
advice.
Lithium-Ion cordless hammer drill
xINR18/65-y: Cylindrical lithium
Ion battery cells with max diameter
of 18mm and max height of 65mm;
"x" represents a number cells serial
connected, blank if 1; "-y" represents
a number of cells paralleled
connected, blank if 1.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
ASSEMBLY AND
OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch
and disconnect tool from power source when
changing accessories. Always ensure the bit is secure
before starting the tool. Damage to the Chuck or a
loose bit may cause possible personal injury.
--Removing the bits
--Inserting the bits
OPERATION
FORWARD/REVERSE
ROTATION CONTROL
WARNING: Never change
the direction of rotation
when the chuck is rotating, wait
until it has stopped!
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B1
See Fig. B2
See Fig.C1,
C2, C3
EN