Installing Lightbulb And Lens - Genie Chainlift 2020 Manual De Operación Y Mantenimiento

ABOUT DUAL FREQUENCY
REMOTE TRANSMITTERS
Your garage door opener (GDO) features a unique
dual frequency remote control system for reliable
service in today's crowded airwaves. Overcrowded
airwaves may intermittently interfere with GDO's
remote control system. The dual frequency feature
greatly reduces the possibility of unwanted
interference.
The receiver in the GDO's powerhead can receive
signals at 315 AND 390 MHz. The remote is factory
set at 315 MHz. See Figure below for frequency
selector switch.
Switch your remote control frequency when:
• Remote does not have adequate range.
• Remote works inconsistently with fresh battery
installed - LED feedback lights up when pressing
button.
• Programming your car's HomeLink® system.
To program a HomeLink® device:
(This GDO is HomeLink® compatible.)
• Use a small flat screwdriver to switch the
frequency selector to 390 MHz.
• Follow the HomeLink® instructions in your car
owner's manual.
• Reset the remote control frequency to 315 MHz for
everyday use.
• Each Remote Control must be programmed
separately.
• The Remote Controls will not close the garage
with malfunctioning Safe-T-Beam® System.
• Program Remote Controls, while at least 24"
from Antenna Wire.
• If the red Learn Indicator Light blinks rapidly,
programming stopped. Restart programming.
• Each Button on a multi-button Remote Control
is for a different Opener. Cannot use more
than one Button for same Opener.
• A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see "To Erase All
Receiver Memory."
I
NSTALLATION OF
A Install a 100 Watt light bulb (not included) into Light
Socket (Figure 14):
• Rough service, 130 Volt bulbs are recommended.
B Install Lens into slots in Motor Cover.
• Insert Bottom hinges into slots provided in metal front
cover of Power Head.
• Flip Lens up and fasten with molded latches on lens.
12
NOTE
L B
ENS AND ULB
Figure 14 Install Lens and Light bulb
Transmitter Compliance Statement
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
Screw
on
Bottom