Electrical Grounding Instructions - ELICA ELG630S2 Guía De Instalación, Uso Y Mantenimiento

Electrical Connection
I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
TURN OFF POWER CIRCUIT AT THE SERVICE PANEL
BEFORE WIRING THIS UNIT.
120 VAC, 15 OR 20 AMP CIRCUIT REQUIRED.

ELECTRICAL GROUNDING INSTRUCTIONS

This appliance is fitted with an electrical junction box with 3
wires, one of which (green/yellow) serves to ground the ap-
pliance.
To protect you against electric shock, the green and yellow
wire must be connected to the grounding wire in your home
electrical system, and it must under no circumstances be cut
or removed.
Failure to do so can result in death or electrical shock.
Facing the front of the range hood, remove the left
knockout and the Junction box cover and install the
conduit connector (cULus listed) in junction box.
If not already done, install a
Use UL listed wire connectors and connect black wires
together.
Use UL listed wire connectors and connect white wires
together.
Connect green (or bare) ground wire from home power
supply to yellow-green ground wire in terminal box using
UL listed wire connectors.
Install terminal box cover.
UL listed
wire nut
House
wiring
Knockout
Junction
box cover
⁄ " conduit connector in j-box.
1
2
Metal
electrical
conduit
Mounting the duct cover
Note: Upper Duct Cover may be placed upside down to hide
(or unhide) louver holes.
Position the duct cover over the mounted hood.
Slide the bottom of the duct into the canopy area.
Position the top of the duct over the duct mounting
bracket. If a telescopic duct cover is used, grab the upper
part of the telescopic duct cover, pull it and place it in the
duct cover mounting bracket.
Secure the top of the duct with 2 assembly screws
provided.
Secure the bottom of the duct with 2 assembly screws
provided.
Install the charcoal filter on the back side of the grease
filter, install both on the range hood and turn power on at
service panel. Check operation of the hood.
If range hood does not operate:
Check that the circuit breaker is not tripped or the house
fuse blown.
Disconnect power supply. Check that wiring is correct.
To get the most efficient use from your new range hood, read
"Description of the Hood" and "Control" sections.
Keep your Installation Instructions and Use and Care Guide
close to range hood for easy reference.
11