First Ride; Charging; Storage Compartment - Segway S-PLUS Manual Del Usuario

There are safety risks when learning to ride the Segway S-PLUS. You must read the
5

First Ride

Safety Instructions and follow the New Rider Tutorial in the App before your first ride.
For your safety, your Segway S-PLUS is not activated at this time and will beep
occasionally after Power ON.
Until activated, the Segway S-PLUS maintains a very low riding speed and steering
sensitivity, and should not be ridden. Install the App on your mobile device (with
Bluetooth 4.0 or above), connect to the Segway S-PLUS with Bluetooth, and follow
the App instructions to activate your Segway S-PLUS and follow the training
procedures.
Scan the QR code to download the App (iOS 8.0 or above, Android™ 4.3 or above).
1 Install the App and register/login.
3 Click "Vehicle"→"Search device" to connect
to your Segway S-PLUS. The Segway
S-PLUS will beep when the connection is
successful. The Bluetooth icon will stop
blinking and remain illuminated.
If your Segway S-PLUS intermittently sounds an alarm, stop riding and check the App (if connected)
for details.
08
2 Power ON the Segway S-PLUS. The
Bluetooth icon blinking indicates the Segway
S-PLUS is waiting for a connection.
Vehicle N Fans Club Discover Me
6

Charging

Do not connect the charger if the charge port or charge cable is wet.
Charge port
Your Segway S-PLUS is fully charged when the LED on the charger changes from red (charging) to
green (trickle charge).
7

Storage Compartment

1. Opening and Closing: to open, first press the button, then pull off the cover; to close, insert the
bottom of the cover first, then press closed until it clicks.
Using: stow the remote control or camera inside the storage compartment, as shown. Use the
2.
retaining strap to hold the item securely.
1
The storage compartment is water resistant, but not waterproof. It cannot prevent extensive rain or
water from entering.
Open the rubber cap Insert the plug
into the socket
2
Remote Camera
09