Checks And Adjustments - Honda HF2315 Manual De Instrucciones Y Especificacion

Rear axle
This is a sealed single unit which does not require maintenance. It is
permanently lubricated and this lubricant does not need changing or
topping up.
6.2.3 Battery
To ensure long life to the battery, it is es-
sential to keep it carefully maintained.The
battery on your machine must be
charged before using for the first time
( 3.4).
During periods when it is not used,
the charge level can be kept con-
stant by using the maintenance
battery charger supplied. For this
purpose the machine is supplied
with a connector (1) to be con-
nected to the corresponding bat-
tery charger connector.
IMPORTANT No device other than the battery charger is to be
connected to this connector.
IMPORTANT The charge must be maintained with the battery
charger, following the instructions given in the instruction booklet.
Other recharging systems may definitively damage the battery.
A low battery must be recharged as soon as possible. Otherwise, ir-
reparable damage could be done to the battery's elements.
Periodically check the electrolyte level. When topping off, use ONLY
distilled water for batteries.

6.3 CHECKS AND ADJUSTMENTS

6.3.1 Dismantling, sharpening and balancing blades
Blades that are badly sharpened tear at the grass, reduce collection
and make the lawn turn yellow.
When accessing the blades, remove the cutting
IMPORTANT
deck that is equipped with a quick release system that makes their
removal from the machine easy.
a) Removing the cutting deck
HF2315 ••
◊
After moving the cutting height
lever to position «1», loosen the
engagement cable adjuster (1),
pull it out and release the spring
(2).
Free the blades belt (6) from the
clutch pulley (7).
Release the two cotter pins (8)
which hold the two rods (9) onto
the frame.
EN 16
Release the three cotter pins
(10) holding the pins onto the
lifting lever, being careful not to
touch the nuts or locknuts in or-
der to keep them parallel for as-
sembly.
Having checked that there is
nothing in the way, the deck can
be removed, taking it out to-
wards the left so that all the pins
come out of their positions.
When assembling, perform the
operations described above in
reverse while making sure that
the front terminal of the collector
channel properly fits into the exit
of the cutting deck.
HF2417HM• HF2417HT•
Remove the "Mulching cable".
Remove the pin (1) and extract
the ring (2). Loose the nut (3)
and remove the cable (4).
HF24•• •• HF26••
◊
Put the cutting height adjustment
lever into the notch at position
«1».
Release the spring (1) of the
blade engagement.
Loosen the register (2) and ex-
tract it from the seat.
Free the blades belt (4) from the
clutch pulley (5).
HF24•• ••
◊
Remove the two cotter pins (6)
from the two front connecting
rod pins (7), without loosening
or changing the position of the
nuts (8) and locknuts (9).
Remove the two cotter pins (10) of the
rear pins.
After checking that there are no obstruc-
tions, remove the deck in such a way that
all the pins come out of their housings.
HF2622H♦•
1
3
2
••
◊
1
4
2
10