Emission Control Information - Maruyama BL9000-GT Manual Del Proprietário

Sopladora de cargar a la espalda
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STORAGE
For long-term storage of the Backpack Blower, first perform all regular maintenance procedures and needed repairs. Empty the
fuel tank. Disconnect the fuel supply line from the carburetor and depress the primer bulb until fuel stops discharging from the
fuel-return line.
Start the engine and allow it to run until it stops. Pull the starter cord a few times to remove any excess fuel from the engine.
Remove the spark plug and insert a small amount of oil into the cylinder. Slowly pull the starter cord and bring the piston to a
position closest to the spark plug hole. Re-install the spark plug. Apply a thin coating of oil to all the metal surfaces and store the
Backpack Blower in a dry place.

EMISSION CONTROL INFORMATION

EMISSION CONTROL INFORMATION
To protect the environment in which we all live, Maruyama has incorporated an exhaust emission control system.
EXHAUST AND EVAPORATIVE EMISSION CONTROL SYSTEM
The system reduces the amount of pollutants discharged into the atmosphere by the exhaust of this engine. The fuel tank,
ignition and exhaust systems of this engine have been carefully designed and constructed to ensure an efficient engine with low
exhaust pollutant and low evaporate emission levels. If you purchased your (Blower, Trimmer, Hedge Trimmer) in the state of
California, the fuel tank includes low evaporative emission system.
MAINTENANCE AND WARRANTY
Proper maintenance is necessary to ensure that your engine will continue to have low emission levels. This Owner's/Operator's
Manual contains those maintenance recommendations for your engine. Those items identified by the Periodic Maintenance Chart
are necessary to ensure compliance with the applicable standards.
As the owner of the (Blower, Trimmer, Hedge Trimmer), you have the responsibility to make sure that the recommended
maintenance is carried out according to the instructions in this Owner's/Operator's Manual at your own expense.
The Maruyama Limited Emission Control System Warranty requires that you return your (Blower, Trimmer, Hedge Trimmer) to an
authorized Maruyama (Blower, Trimmer, Hedge Trimmer) dealer for remedy under warranty. Please read the warranty carefully,
and keep it valid by complying with the owner's obligations it contains.
TAMPERING WITH EMISSION CONTROL SYSTEM PROHIBITED
Federal law and California State law prohibit the following acts or the causing there of:
(1) the removal or rendering inoperative by any person other than for purposes of maintenance, repair, or replacement, of any
device or element of design incorporated into any new engine for the purposes of emission control prior to its sale or delivery to
the ultimate purchaser or while it is in use, or (2) the use of the engine after such device or element of design has been removed
or rendered inoperative by any person.
Among those acts presumed to constitute tampering are acts listed below: Do not tamper with the original emission related parts.
• Carburetor and internal parts
• Spark plug
• Magneto or electronic ignition system
• Fuel filter
• Muffler or any internal portion of the muffler
• Air cleaner element
• Fuel Tank
ADJUSTMENT
IDLING SPEED ADJUSTMENT
1. Idle speed is the only available adjustment.
2. Do not tamper with the carburetor setting to increase the maximum engine speed.
3. If adjustment is needed, have it performed by your authorized MARUYAMA service dealer.
Carburetor adjustments are made at the factory and are not adjustable without disassembling the carburetor.
English-13

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido