Denon DJ PRINE 4 Guia De Inicio Rapido página 6

29. Play/Pause: This button pauses or resumes playback.
Press and hold Shift and then press this button to "stutter-play" the
track from the initial cue point.
30. Vinyl: Press this button to activate/deactivate a "vinyl mode" for the
platter. When activated, you can use the platter to "scratch" the track
as you would with a vinyl record.
31. Key Lock / Key Sync: Press this button to activate/deactivate Key
Lock. When Key Lock is activated, the track's key will remain the
same (0%) even if you adjust its speed. Press and hold Shift and
press this button to reset Key Lock.
Press and hold this button to activate key sync.
32. Pitch Fader: Move this fader to adjust the speed (pitch) of the track.
You can adjust its total range with the Pitch Bend buttons.
33. Pitch Bend –/+: Press and hold one of these buttons to momentarily
reduce or increase (respectively) the speed of the track.
Press and hold Shift and then press one of these buttons to set the
range of the pitch fader.
34. Shift: Press and hold this button to access secondary functions of other controls.
35. Edit Grid: Press and hold this button to enable beat grid editing.
Press and hold Shift and then press this button to reset the beat grid.
36. Grid Marker: When beat grid editing is enabled, press either of these buttons to move a downbeat marker backward
or forward based on the current analyzed grid.
Press and hold Shift and then press these buttons to halve or double the current tempo.
37. Slip: Press this button to enable or disable Slip Mode. In Slip Mode, you can jump to cue points, trigger loop
rolls, or use the platters, while the track's timeline continues. In other words, when you stop the action, the track
will resume normal playback from where it would have been if you had never done anything (i.e., as if the track
had been playing forward the whole time).
38. Censor / Reverse: Press this button to activate/deactivate the Censor feature: the playback of the track will be
reversed, but when you release the button, normal playback will resume from where it would have been if you
had never engaged the Censor feature (i.e., as if the track had been playing forward the whole time).
Press and hold Shift and then press this button to reverse the playback of the track normally.
39. Performance Pads: These pads have different functions on each deck depending on the current pad mode.
40. Hot Cue: Press this button to enter Hot Cue Mode. See the User Guide for more information.
41. Loop: Press this button once to enter Manual Loop Mode. See the User Guide for more information.
42. Roll: Press this button to enter Roll Mode. See the User Guide for more information.
43. Slicer: Press this button to enter Slicer Mode. See the User Guide for more information.
44. Parameter /: Use these buttons for various functions in each Pad Mode. See the User Guide for more
information.
45. Auto Loop/Loop Move: Turn this knob to set the size of an automatic loop. The value will be shown in the
touchscreen and platter display.
Press this knob to activate or deactivate an automatic loop at the current location of the track.
Press and hold Shift and turn this knob to shift the active loop to the left or right.
46. Loop In/Loop Out: Press either of these buttons to create a Loop In or Loop Out point at the current location.
Their placement will be affected by the Quantize and Smart Loops settings. See the User Guide for more
information.
6
45
37
46
38
23
24
25
26
40 41 42 43
27
28
39
29
30 31
22
32
33
34
35
36
44