Mounting Steps - Lenze E84AZESM Serie Instrucciones Para El Montaje

5 Mechanical installation
Mounting variant

Mounting steps

5.2.2 Mounting steps
Proceed as follows for installation:
1. Prepare threaded holes on the mounting plate.
2. Equip threaded holes with screws and washers.
–
Use 8 screw and washer assemblies or hexagon socket screws with
washers.
–
Do not fully tighten the screws.
3. Mount the filter onto the prepared mounting plate.
–
Only tighten the screws hand−tight.
4. Mount the standard device onto the prepared mounting plate.
–
Only tighten the screws hand−tight.
5. If required, pre−assemble further units.
6. Adjust all units.
7. Screw all units onto the mounting plate.
Filter
E84AZESM1834LD
E84AZESM2234LD
E84AZESM2234LDN001
E84AZESM3034LD
E84AZESM3734LD
E84AZESM4534LD
E84AZESM4534LDN001
Tab. 2 Data of threaded holes and screws
46
Mounting plate
M6 M6
M8 M8
l
Standard device
[Nm]
[lb−in]
4
M6
35
6
M8
62
EDK84AZESxx DE/EN/FR/ES/IT 5.0
E84ZESx008
[Nm]
[lb−in]
M6 x 12
4
...
35
M6 x 16
4
M8 x >16
35