Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Inductance Adjustment
• The welder is built with an inductance adjustment (I).
• Increase the inductance value through the adjusting
knob.
• A high inductance value causes that the weld bead
applied will have less penetration and will make a thinner
bead.
Feeding Time Adjustment
• The welder is built with and adjustment feature (J) to
regulate the time the micro wire stops after cutting the
micro wire feed through the torch.
• If the value is adjusted to the minimum, the micro wire
feed will instantly stop.
• If the value is adjusted to the maximum, the micro wire
feed will stop after 2 seconds the micro wire feed is cut.
• This function is useful to prevent malformations in the
micro wire tip and to improve the bead aesthetics.
E
Torch Operation
Manual mode:
• Set the torch selector (2) in 2 steps.
• During normal operation, the torch will feed the micro
wire only at pressing trigger (K).
• To stop the micro wire feed, release the trigger.
Automatic mode:
• Set the torch selector in 4 steps.
• During normal operation, the torch will feed the micro
wire when pressing the trigger (K).
• Once the electric arc is on you may release the trigger.
The micro wire will keep on feeding automatically.
NOTE: The electric arc shall not be interrupted otherwise
the micro wire automatic feed will also stop.
• To stop the micro wire feed, press and release the
trigger.
SMAW
• Set the soldering process selector (1) into the SMAW mode
(coated electrode
).
• Set an electrode adequate for the job on the electrode
holder clamp.
• When the electrode has been consumed from 0,5" to 1"
from the electrode holder, replace it with a new one to keep
on welding.
CAUTION
• The electrode burns in high temperatures.
Do not try to manipulate the electrode remains with your
hand. Save the remains in a metal container.
• Open the electrode holder pincer to hold the new
electrode. Hold by the uncovered end. Do not hold the
electrode by the covered part.
14
ENGLISH
Start Up
V
A
5
6
5
6
5
6
5
6
4
7
4
7
4
7
4
7
3
8
3
8
3
8
3
8
2
2
2
2
9
9
9
9
1
1
1
1
10
10
10
10
I
J
6
7
2
8
PASO 2
9
10
PASO 4
Overload Protection
• The welder is built with a thermal protection to guard
against overload. When an overload strikes, the welder will
automatically turn off and the overload light (L) will light
up. Allow the unit to cool down. The thermal protector will
restart the unit when the temperature is back to safe limits.
L
K
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
