Technical Specifications; Technical Data; Power Requirements - Truper SOMI-210X Manual De Instrucciones

Technical specifications

Voltage
Current
Welding Process
Open Circuit Voltage
Current Range
Duty Cycle
Output values specified are with a 68 ºF
Micro wire Diameter
Micro wire Speed
Electrode Diameter
Cooling Type
Insulation
Conductors
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING

Power Requirements

WARNING
• The tool shall be grounded while in use to prevent electric shock.
The welder shall be set up as close as possible from the main power source. Check the supply carries the same voltage indicated
in the motor nameplate.
WARNING
• This tool shall be grounded.
• Power cables are coded with the following colors:
CAUTION
• When using the welder together with more tools sharing the same ground, connect in parallel. Never in series.
CAUTION
• The gauge of the ground conductor cable shall not be of a smaller gauge than the power supply cable.
CAUTION
• A professional electrician shall carry out the connection to the power supply.
• Always confirm the input voltage connection stated in the welder nameplate matches the power
CAUTION
supply.
• The power cable gauge shall comply with the following requisites:
CAUTION
Switch
Fuse (Rated Work Current)
Electric Wire
* Fuse fusion current is double than its rated current.
Code
13190
220 V
39,5 A
MIG : 50 A - 200 A c.c. | SMAW : 30 A - 200 A c.c.
Temperatures higher than the work cycle may be reduced.
Type: 6013
Class I
30 A
40 A ( * )
2,5 mm
2
SOMI-210X
Description
INPUT
Rated Input Capacity
OUTPUT
MIG and SMAW
55 V c.c.
60% - 6 minutes' work per 4 minutes' rest.
0.023" | 0.031" | 0.035" | 0.039"
78.7 in/min - 551.1 in/min
3/32" 1/8"
6011
7018 3/32" 1/8"
Fan Forced
IP Grade
12 AWG x 3C with 221 °F insulation temperature
Power cord grips used in this product: Type "Y".
Build quality: Basic insulation
Thermal insulation on motor winding: Class H
• If extension cables are needed between the welder and
the work piece increase the welding cable caliber to keep
the welder power output with a potential drop not higher
than 4 V
MIG & STICK Multi-Process Welder
Frequency
5/32" 3/16"
5/32"
IP21S
Authorized Service Center.
GREEN
WHITE
BLACK
ENGLISH
60 Hz
8,7 kVA
GROUND
CURRENT
CURRENT
3