User Settings - EnviroBoss EB130 Manual Del Propietário

USER SETTINGS

Only menu items followed by a greater-than symbol (>) can be adjusted. If no keys are selected for 5 minutes on screens: INLET
OUTLET, GRAIN, the display will return to normal display mode. In all the other menu items, the display with return to the normal
display mode after 20 seconds. Items without the symbol (>) are for information only and cannot be changed or reset.
Press DISPLAY
MENU to proceed to
the next menu item. ↓
□
1. JOB HRS RESET >
˃
PWR INTERRUPT X
2. INLET OUTLET
For information only.
100' 80% 115' 30%
3. GRAIN DPR
Note: Unit displays GPP if set to Fahrenheit or g/kg if set to Celsius. To change this setting, see menu item 9.
XX GPP
4. FILTER CHECKED
˃
XXX HRS >
5. COIL CLEANED
˃
XXX HRS >
6. HUMIDISTAT
˃
MODE OFF >
7. HUMIDISTAT
˃
SETPOINT XX% >
8. LANGUAGE
˃
ENGLISH >
9. TEMP UNITS
˃
'F >
10. COIL TEMP
For information only.
XX'
11. COMP CURRENT
For information only.
XX.X A
12. FIRMWARE
For information only.
3.0X FXXX-XXX
13. LIFE HOURS
XXXX HRS
(Returns to
top menu item.)
The following section available only on wireless-equipped units.
14. SENSOR ID
XXXXXXXX
(Returns to
top menu item.)
BEFORE STORAGE OR TRANSPORT
To reduce the possibility of drips when moving the
unit, follow these additional steps to ensure that all
water is removed from the unit.
NOTICE: The unit will complete the defrost cycle even if
the unit is turned off but still plugged in. If the unit is
07-02333B EB130
Press ˃ MENU SELECTION to change the setting.
1. JOB HR RESET 0
Press ˃ to reset to 0.
PWR INTERRUPT 0
5. FILTER CHECKED
Press ˃ to clear filter hours.
0 HRS
5. COIL CLEANED
Press ˃ to clear coil hours.
0 HRS
Press ˃ to turn ON or OFF. For maximum dehumidification, make sure
6. HUMIDISTAT
MODE ON > HUMIDISTAT is OFF.
Press ˃ to cycle through 40%–90% at 5% increments (default is 50%).
8. IDIOMA
˃
ESPANOL >
9. TEMP UNITS
Press ˃ to change to °F or °C.
'C >
→
8. SPRACHE 8. LANGUE
˃
DEUTSCH > FRANCAIS >
unplugged during the defrost cycle, excessive water may
accumulate in the unit and may drip out when you move
the unit.
NOTICE: To ensure the condensate tank empties
completely while purging, make sure the unit is placed
upright on a horizontal surface.
4
Press ˃ to change
language options.
EnviroBoss