Troubleshooting - EnviroBoss EB130 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

F A U L T
Water drips out
when moving unit
Unit does not
operate
Unit operating,
but room not dry
Unit collects too
little water
If the problem you are experiencing is not listed here, call your local distributor or contact
our Service Department at 800-932-3030 for further assistance.
SPECIFICATIONS
Model
Water removal AHAM
(80°F/60% RH)
Water removal saturation
(90°F/90% RH)
Process air (max.)
Dimensions
(H × D × W)
Weight
Amps
Volts
Frequency
Power
Noise level (avg.)
Operating range
Construction
Safety
Specifications are subject to change without notice. Some values
may be approximate.
*Fan speed varies automatically for optimized performance.
WARNING: This product and other substances
that may become airborne from its use contain
chemicals, including lead and phthalates, known to the
State of California to cause cancer, birth defects, or
other reproductive harm. For more information, go to
P65Warnings.ca.gov
07-02333B EB130
C A U S E
Unit was unplugged before
purging was complete.
Unit not switched on.
No power to machine.
Not enough time to dry.
Poor air movement in room.
Excessive moist air infiltration.
Room air is dry.
Room temperature is too low.
Filter is full.
Coils are clogged.
EB130
130 pts. | 61.5 L / day
230 pts. | 108.8 L / day
330 CFM
32.1 × 19.8 × 20.0 in.
81.5 × 50.3 × 50.8 cm
100 lbs. | 45 kg
8A
115V
60Hz
920W
60 dB
33°F–100°F | 1°C–38°C
Rotomolded shell
ETL certified CSA 22.2 no. 92
S O L U T I O N
Purge unit before moving. See "BEFORE STORAGE OR
TRANSPORT," above.
Switch unit on.
Plug in unit; check power cord connection at wall outlet and at
base of unit.
Make sure "Humidistat" is OFF.
Allow more time for drying.
Increase air movement with air movers.
Seal off area to reduce infiltration.
Make sure "Humidistat" is OFF.
Confirm humidity level with hygrometer.
Increase room temperature.
Check filter. Replace as necessary.
Check coils. Clean as necessary.
Replacement filters: Part no. 08-02063 (pack of 24).
Available from your EnviroBoss distributor.
FOR PARTS AND SERVICE CALL YOUR LOCAL
DISTRIBUTOR or EnviroBoss at 800-932-3030.
For proper disposal, this unit should be taken to a recycler
licensed to process refrigeration equipment.
9
EnviroBoss

Publicidad

Tabla de contenido
loading

Tabla de contenido