Operation - Dimplex CDFI1000-PRO Manual Del Propietário

Operation

Figure 7
A
WARNING: This unit must be
properly installed before it is
used.
There are three different control
options available for the unit:
manual (under the media), tethered
controller (must be connected to the
unit) and a remote control.
The CDFI1000-PRO unit has two
separate internal modules that are
controlled by the settings entered
on the left side (primary). Finer
adjustment can be done using the
controls on the right module to have
both modules operating at the same
level (secondary).
!
NOTE: When the unit is used in
an environment where background
noise is very low, it may be possible
to hear a sound which is related to
the operation of the flame effect.
This is normal and should not be a
cause for concern.
14
B C D E
Figure 8
Remote Control
Controls
A. On/Off Switch
Supplies power to the unit.
B. Standby
Turns flame effect on or puts the
unit into standby mode.
!
NOTE: When the unit is first
turned on the lights will come on
and mist will appear 45 seconds
later.
F
G
Tethered
Controller
A
RELEASE FOR SAMPLING
B ARTWORK UPDATED AS PER DNA
www.dimplex.com
HC
-----
17-05-17
----- HC
06-06-17